Table of Contents
Advertisement
Hoses
and
Couplers
A.
Front Opening Portables
Proper routing
of hoses for Front Opening Portables is shown in Figure 42
Tub removal is not required to perform
the following
operations
FIGURE 42
NOTE:
Tub
is removed
only
to
show
location
and
routinB
of hoses
To replace the Fill Hose:
1,
Lay unit on its back,
2,
Disconnect
inlet hose at inlet valve
3.
Stand upright, remove top,
4,
Detach saddle hose clamp
5
Pull inlet hose up and out of cabinet.
6.
Disconnect
inlet hose from coupler,
Reinstall new inlet hose in reverse of the above - Be certain routing
is proper and that there are no twists
or kinks
in the hose. Check hose connections for leaks and test movement
of hose in and out of cabinet.
NO TE:
On some models, both the fill hose and drain hose are permanently
attached
to the coupler.
To replace the Drain Hose:
_,
It is best to leave unit in upright, position and remove access panel
2,
Disconnect drain hose from pump casting - CAUTION
- be prepared to catch approximately
one Q) quart of
water
from pump housing and hose.
3.
Disconnect
fill hose at inlet (still standing upright].
4,
Remove top assembly
42
Hide quick links:
Advertisement
Table of Contents
