Table of Contents
Advertisement
9. Remove the drive retainer clip from the side of the drive cage of bay 1 or bay 2. Slide the drive
retainer clip to the front to remove it from the drive cage; then, snap the drive retainer clip into the
screw holes on the side of the drive.
1
EMC shield
2
Tape drive
3
Drive retainer clip
10. Remove the EMC filler.
11. Push the drive into the bay.
Note: A tape drive can be installed in bay 1 or bay 2
12. Connect one end of the applicable signal cable into the rear of the drive and make sure that the
other end of this cable is connected into the applicable connector on the system board (see "Power
and signal cables for internal drives" on page 151.)
13. Route the signal cable so that it does not block the airflow to the rear of the drives or over the
microprocessor and dual inline memory modules (DIMMs).
14. Connect the power cable to the rear of the drive. The connectors are keyed and can be inserted only
one way.
15. Go to "Completing the FRU replacement" on page 190.
Removing a hot-swap hard disk drive
This procedure applies only to server models that have hot-swap hard disk drives.
Attention: To maintain proper system cooling, do not operate the server for more than 10 minutes
without either a drive or a filler panel installed in each drive bay.
To remove a hot-swap hard disk drive, complete the following steps:
146
ThinkServer TS200 Types 6522, 6523, 6524, 6525, 6526, 6528, 6529, and 6530: Hardware Maintenance Manual
Advertisement
Table of Contents
