Installation Accessories; Final Installation Checklist - Maytag Washer/Dryer Installation Instructions Manual

INSTALLATION ACCESSORIES FINAL INSTALLATION CHECK LIST
i •Vent hood - 4" (10.16cm) opening- 059129 _ Instruction and Installation Kit have been
'_ • Aluminum pipe - 4" x 24" (10.16cm x 60.96cm) removed from dryer.
_ - 059130 [] Shippingbolts and strapshave been removed.
! , _ • Aluminum elbow - 4" (10.16cm)- 059131 [] Assurethat the dryer is slid back and is
,_ • Aluminum window plate - 15" x 20" (38.10cm x securedto the washer.
50.80cm) -4" (10.16cm) hole- 059134 [] Vinyl feet have been installed.
i • Flexible aluminum vent duct - 4" (10.16cm) [] Washer/dryeris level with all legs firmly on
ii diameter - 38" (81.28cm)length stretches to the floor, with the lock nuts tightened against
' 8' (2.44cm) 304353 the base.
! • Clamp for flexible aluminum duct - 304630 _ Drain hose is properly located into drain
_: • Exhaust duct kit for base or left side exhausting facility, snapped into drain hose strap and is
.... ii - 33001881 nbt kinked.
• Rectangularvent kits - 059144 [] Gas Models- gas is turned on, there are no
i, • Back draft damper 4"- 059146 gas leaks.
i ! • NATURALto LP conversion kit [] Water is turned on and checked for leaks at
30619_
faucet and water valve connections.
n
i - LP to NATURALconversion kit - 33001287 C] Washer fills properly on all temperature
• Anchor bracket kit - 303740 selections.
_i • Heatingelement conversion kit, _ Exhaust duct work is hooked up and joints
i_ 208 v., - 308590 (NOT FOR CANADA) taped.
ll • Grounding wire - 311155 [] Use rigid or stiff walled flexible metal vent
!t • Ground clamp - 301548 material.
i! • Powercords - 240 v, 30 A [] Plastic flexible duct is NOT used.
I_ 4' - 3-wire- 33001780 [] Washer and dryer are plugged into electrical
5' - 3-wire - 33001822 outlet and are properly grounded.
6'- 3-wire - 33001823 [] Test for proper operation by running the
10' - 3-wire - 33001838 washer through a complete cycle.
4' - 4-wire - 33001781
6' - 4-wire - 33001824 1. Select Cotton/Sturdy,Hot/Cold and Max
Extract. Make sure the Extra Rinse
6'-4-wire- 33001825 option is not selected.
2. Set the timer into the Heavy-Normal-Light
wash band and press the Start/Stopbutton.
3. Verify the washer is filling from the hot
water valve.
4. Verify the washer stops filling.
5. Push Start/Stop to stop washer.
6. Set the timer into the Final Rinse
increment and press the Start/Stop
button to restart the washer.
7. Verifythe washer is filing from the cold
water valve.
8. Verify the washer stops filling.
9. Wait 30 seconds for the timer to advance
itself one increment into Spin.
10. Verify the washer spins. This will take
several minutes as the door needsto lock
and distribute the load. _-
11. Pull on the doorto make sure it has locked.
12. Reset the washer to start position.
[] Dryer runs, heats,shuts off.
Page 24