Table of Contents
Advertisement
McCall
Installation, continued
Electrical Connection
Refer to the amperage data list in the
SPECIFICATIONS or the serial tag data and your
local code or the National Electrical Code to be
sure the unit is connected to the proper power
source. A protected circuit of the correct voltage and
amperage must be run for connection of the supply
cord or permanent connection to the unit. The power
must be turned off and disconnected whenever
performing maintenance or repair functions.
Permanently connected units must be connected
in accordance with NEC Article 422 Appliances,
C-Disconnecting means. It is the responsibility of
the end user to provide the disconnect means to
satisfy the authority having jurisdiction.
The power cords supplied with this equipment are three-pronged
plugs and must be connected to a three-pronged wall outlet for
proper grounding. Do not use an adapter to connect to a two-
pronged outlet. The three pronged-outlet provides a ground
connection which must be used to prevent a shock hazard.
Have the wall outlet checked by a qualified
electrician to be sure a proper ground is present
and that the outlet provides the correct voltage and
required amperage to match the rating plate.
Any power cord that is frayed or damaged should be replaced.
When disconnecting the unit from the power source, do not pull
on the wire. Firmly grip the plug and remove from outlet.
The plugs shown in Figure 3 are used on the various models.
McCall
Figure 3. Plug Configurations
Hide quick links:
Advertisement
Table of Contents
