Pride Quantum Series Owner's Manual page 27

V . C O M F O R T
Armrest Angle Adjustment
To change the armrest angle:
1. Lift the armrest straight up so that it is perpendicular to
the floor. See figure 18.
2. Loosen the locking nut.
3. Turn the adjusting screw to raise or lower the front of
the armrest.
4. Tighten the locking nut to lock adjusting screw into place.
Armrest Height Adjustment
To change the armrest height:
1. Loosen the setscrews on the armrest See figure 18.
2. Raise or lower the armrest to the desired height.
3. Tighten the setscrews to secure the armrest.
Controller Position
You can position the controller for either left-hand or right-
hand use.
WARNING! Do not place the controller
cable so that it can be pinched in the
seat frame or the power base frame.
To extend the controller:
1. Flip up the armrest so it is perpendicular to the floor.
2. Loosen the setscrew on the controller bracket. See
figure 19.
3. Slide the controller into or out of the armrest to the de-
sired position.
4. Tighten the setscrew to secure the controller.
To change the controller position:
1. Turn off power to the controller.
2. Disconnect the controller from the power base.
3. Remove the wire ties securing the controller cable to the armrest.
4. Loosen the setscrew on the underside of both armrests. See figure 19.
5. Slide the controller out of the armrest.
6. Transfer the controller to the other armrest.
7. Tighten the setscrew on both armrests.
NOTE: If your power chair is equipped with an optional seating system, loosen the mounting screws in the
controller mounting block, transfer the entire assembly to the opposite armrest and tighten the screws. See
figure 20.
8. Route the controller cable so that it will not be pinched in the seat hinge.
9. Connect the controller cable to the power base.
10. Secure the controller cable to the armrest with wire ties.
Quantum 1107
A D J U S T M E N T S
Figure 19. Underside of Armrest
Figure 20. Controller Mounting Block
www.quantumrehab.com
SETSCREW
MOUNTING
SCREWS
27