Use A Vpn Tunnel - NETGEAR Nighthawk X6 AC3200 User Manual

Use a VPN Tunnel

After you set up the router to use VPN and install the OpenVPN application on your
computer, you can open a VPN tunnel from your computer to your router over the Internet.
For the VPN tunnel to work, the local LAN IP address of the remote R8000 must have a
different LAN IP scheme from that of the local LAN where your VPN client computer is
connected. If both networks use the same LAN IP scheme, when the VPN tunnel is
established, you cannot access your home router or your home network with the OpenVPN
software.
The default LAN IP address scheme for the R8000 is 192.x.x.x. The most common IP
schemes are 192.x.x.x, 172.x.x.x, and 10.x.x.x. If you experience a conflict, change the IP
scheme either for your home network or for the network with the client VPN computer. For
information about changing these settings, see
page 100.

To open a VPN tunnel:
1. Launch the OpenVPN application with administrator privileges.
The OpenVPN icon displays in the Windows taskbar.
Tip: You can create a shortcut to the VPN program, then use the shortcut
to access the settings and select the run as administrator check
box.Then every time you use this shortcut, OpenVPN automatically
runs with administrator privileges.
2. Right-click the OpenVPN icon.
Nighthawk X6 AC3200 Tri-Band WiFi Router
Use VPN to Access Your Network
141
Change the LAN TCP/IP Settings on