Table of Contents
Advertisement
Linksys
Class Limit Power Mode
•
To configure class limit power mode, do the following:
STEP 1 Click Configuration > Port Management > PoE > Class Limit Power
Mode .
The following fields are displayed for ports on which the port limit power mode
is enabled:
PoE Status—Enable or disable PoE on the port .
•
•
Power Priority Level—Port priority is low, high, or critical, for use when the
power supply is low . For example, if the power supply is running at 99%
usage and port 1 is prioritized as high, but port 3 is prioritized as low, port
1 receives power and port 3 might be denied power .
Class—Class configured on this port . The classes are shown in the following:
•
Class
Maximum Power Delivered by Device
•
•
Port
0
15 .4 watt
•
•
•
1
•
4 .0 watt
2
7 .0 watt
•
•
3
15 .4 watt
•
•
•
4
•
30 .0 watt
Max Power Allocation (mW)—Maximum amount of power permitted on
•
this port .
Power Consumption (mW)—Amount of power assigned to the powered
•
device connected to the selected interface .
•
Operational Status—Whether the Class Limit mode is enabled or disabled
on the port .
STEP 2 Select a port and click Edit . Enter the fields as described above .
STEP 3 Click Apply . The PoE settings for the port are written to the Running
Configuration file .
Chapter 5 Port Management
23
Advertisement
Table of Contents
