General Access; Control Panel - Potterton Osprey CF 125 Installation & Service Instructions Manual

Service & Replacement of Parts - Page 21
Fig. 14

4.1 General Access

Warning: Before attempting to remove any component from
the appliance first disconnect the mains electricity supply by
removing the plug from the wall socket or by switching off
the appliance at the external isolating switch and isolate the
gas supply.
Note: The 'O' (Off) position on the boiler standby switch will
leave parts of the boiler Live.
If the appliance gas valve is to be removed it will be
necessary to isolate the gas supply at the appliance isolating
valve.
Important: After removal or replacement of any gas carrying
component a test for gas soundness must be made and
functional check of the controls carried out.
Re-assemble all parts in reverse order.
1. Remove the front door by pulling forward then lifting up,
see Fig. 15.
2. Remove the top panel - 2 screws at rear, pull upwards
and lift off.
3. Lift control panel onto hinges, drop forward, remove 2
screws and pivot forwards.
4. Lift off the metal shield.

4.2 Control Panel

•
Gain General Access - See 4.1
1. Disconnect gas valve and boiler stat & TTB connector.
2. On re-assembly refer to Fig. 12.