To Log In To Alom Cmt; To View Environmental Information - Siemens T1000 Administration Manual

▼

To Log In To ALOM CMT

1. If you are logged in to the system console, type #. (Hash-Period) to get to the sc>
prompt.
Press the Hash key, followed by the Period key. Then press the Return key.
2. At the ALOM CMT login prompt, enter the login name and press Return.
The default login name is admin.
Advanced Lights Out Manager CMT v1.3
Please login: admin
3. At the password prompt, enter the password and press Return to get to the sc>
prompt.
Please Enter password:
sc>
Note – There is no default password when connecting to ALOM CMT for the first
time using the serial management port. When connecting to the system controller
using the network management port for the first time, the default ALOM CMT
password is the last 8 digits of the Chassis Serial Number. The Chassis Serial
Number can be found printed on the back of the server or in the printed system
information sheet which shipped with your server. You must assign a password
during initial system configuration. For more information, refer to the installation
guide for your server and the ALOM CMT guide for your server.
Caution – To provide optimum system security, change the default system login
name and password during initial setup.
Using the system controller, you can monitor the system, turn the Locator LED on
and off, or perform maintenance tasks on the system controller card itself. For more
information, refer to the ALOM CMT guide for your server.
▼

To View Environmental Information

1. Log in to the system controller.
Chapter 2 Managing RAS Features and System Firmware 27