What To Do If; Machine Settings - Zanussi ZTAB 250 User Manual

Clean operating screen and housing
Caution! Do not use furniture cleaners or
aggressive cleaning agents to clean the
appliance.

What to do if ...

Problem
Dryer does not work.
Drying results unsatisfactory.
Loading door does not close.
Drying cycle ends shortly after pro-
gramme starts.
Drying cycle lasts an unusually
long time. Note: After around 5
hours the drying cycle ends auto-
matically.
1) Only dryers with conductance programming
2) Only dryers with removable filter

Machine settings

BUZZER permanent off
1. Turn the programme selector to any pro-
gramme.
www.zanussi.com
Use a damp cloth to wipe down the operating
screen and housing.
Possible cause
Mains plug is not plugged in or
fuse is not working correctly.
Loading door is open.
Have you pressed the
PAUSE button?
Wrong programme selected.
Fluff filter clogged.
Overloading of laundry.
Ventilation slots covered up.
Residue on inside surface of drum
or drum ribs.
Conductance of water at installa-
tion site differs from standard set-
1)
ting of machine.
2)
Filter not in place .
Not enough washing loaded or
washing loaded is too dry for se-
lected programme.
Filter clogged.
Load volume too big.
Laundry insufficiently spun.
2. Press simultaneously the
3. The buzzer is by default always off.
Plug in at mains socket. Check
fuse in fuse box (domestic installa-
tion).
Close loading door.
START Press the
ton again.
Select a different programme the
next time you dry (see "Programme
chart" chapter).
Clean fluff filter.
Observe recommended loading
volumes.
Uncover ventilation slots.
Clean inside surface of drum and
drum ribs.
Re-programme standard setting
for degree of drying (see 'Machine
settings' chapter)
Install filter into place
Select time programme or higher
drying level (e.g. EXTRA DRY in-
stead of CUPBOARD DRY ).
Clean filter.
Reduce load volume.
Laundry must be adequately spun.
and TEXTILE buttons and hold down for
approx. 5 seconds.
Remedy
START PAUSE but-
1)
.
2)
.
DELICATE
9