Kenmore 16238 Assembly And Operation Manual page 23

32.Attach thetwowiresfromthecrosslighter
andthetwowiresfromthesideburner
toanyofthefoursmall t erminals o n
ignitor module as shown.
Next, A ttach thetwowiresfromconsole
assembly t othetwolarge terminals o nignitor
module asshown.
I0nitorModule
(2) Large
Terminals
Important: Be sure to attach wires correctly to terminals.
Correct Incorrect
NOTE: Use one of the supplied plastic
ties to bundle the two large terminal wires
together, and one to bundle the four small
terminal wires together.
33. After wiring ignitor module ensure that all burner knobs
are in the off position before installing the battery.
Install the battery
34. Snap ignitor module tabs into
holes on back left side of front
panel as shown.
NOTE: Do not remove ignitor module
once installed. The plastic mounting tabs
on the ignitor "hook" into the mounting
holes and are not designed to be repeatedly
removed and re-installed Replace battery
in module with module in place..
23