Kenmore 16238 Assembly And Operation Manual page 13

14. Position left side shelf over shelf mounting brackets
15. To begin installation be sure to align large shelf (holes) with the small holes in
the shelf bracket assembly. Insert (2) #10 x 1/2" Truss head screws (phillips drive)
into largest hole on outside rear corner of shelf carefully aligning with small hole in
shelf mounting bracket. Repeat procedure for inside rear.
Rear View
Outside hole
Inside hole
16. To install shelf trim, tilt grill onto opposite shelf supports, align large
holes in shelf bracket and shelf witht the small holes in the shelf trim. Then
place (2) #10 x 1/2" truss head screws into larger holes first (underneath
shelf) and tighten securely.
Front View
/
/
17. After securing shelf trim to shelf/shelf bracket, align large hole on inside
flange with large hole in control console and small hole in casting support
bracket and insert (1) #10 x 1/2" truss head screw.
\
\
\
&
#10 x 1F2Phillips Screw
13