Wolf L Series Installation Manual page 13

L Series Oven Installation
Install the Oven
MOUNT OVEN TO CABINETRY
Once the oven is fully inserted into the opening, locate the
mounting holes on the oven side trim. There are four
mounting holes for a single oven and six for a double
oven. Refer to the illustration below. Use a
drill pilot holes into the cabinet. Using the wood screws
provided, secure the oven to the cabinet.
Failure to install the mounting screws may cause the
oven to tip forward during use.
Location of mounting holes.
OVEN DOOR REINSTALLATION
1) Hold the oven door on both sides and position it with
2) Holding the oven door at an approximate 30° angle
1
/ " drill bit to
16
3) Open the oven door to its fully opened position.
4) Reinstall the hinge retainer plate with upper and lower
5) Open and close the door completely to ensure that it is
IMPORTANT NOTE: Fully extend the hinge claw which is
opposite the hinge pin location and insert into the hinge
pocket prior to inserting opposite side. This will ease the
installation of the oven door.
Oven door reinstallation.
door hinges aligned with openings in the oven frame.
from vertical, slide the hinges into the openings
until the bottom hinge arms drop fully into the hinge
receptacles.
Remove the hinge pin from the appropriate hinge arm.
Refer to the illustration below.
mounting screws.
properly installed.
HINGE
RETAINER
PLATE
UPPER
MOUNTING
SCREW
HINGE PIN
13
wolfappliance.com/specs