Chain Catcher - Replacement; Dismantling The Start/Stop Control; Cleaning And Inspection - Husqvarna 435 Workshop Manual

Safety equipment
6.5 Chain catcher – replacement
If the chain catcher is worn it must be replaced with
a new one.
1
Release the brake by pushing the kickback guard
backwards. Undo the guide bar bolts and remove
the clutch cover, chain and guide bar.
2
Remove the chain catcher and replace it with a
new one. Check that the vibration damping spring
Fig 12
locates correctly against the crankcase when you
bolt the new chain catcher in position. (see figure
12)

6.6 Dismantling the start/stop control

1
Remove the cylinder cover and air filter.
2
Loosen the screw and dismantle the control (see
figure 13).
3
Loosen the filter holder from the rubber mountings
(B). (see figure 13)
4
Cut off the starlock washer and pull out the control
from the shaft on the filter holder.(see figure 14)
Fig 13

Cleaning and inspection

Clean and inspect all parts carefully. If there are
any cracks or other defects replace the damaged
parts with new ones. Always use original parts.
20
– English