Starting The Engine; General Information; Ignition Switch; Starting A Petrol Engine - Ford Tourneo Connect Owner's Handbook Manual

GENERAL INFORMATION

General points on starting
If the battery has been disconnected
the vehicle may exhibit some unusual
driving characteristics for approx. 8
kilometres (5 miles) after
reconnecting the battery.
This is because the engine
management system must realign
itself with the engine. Any unusual
driving characteristics during this
period may be disregarded.
Starting the engine by
towing or pushing
WARNING
To prevent damage you must
not push or tow start your
vehicle. Use booster cables and a
booster battery. See Using
booster cables (page 121).

IGNITION SWITCH

Ignition switch positions
Position 0
WARNING
Never return the key to the 0
position when the vehicle is in
motion.
Ignition off. When the key is removed
from the ignition switch, the steering
column lock will be activated as soon
as the steering wheel is turned.

Starting the engine

88
Position I
Steering unlocked. Ignition and all
main electrical circuits are disabled.
The ignition key should not be left in
this position for too long to avoid
discharging the battery.
Positon II
Ignition switched on, all electrical
circuits operational. Warning and
indicator lamps illuminate. This is the
key position when driving, and must
also be selected when being towed.
Postion III
Starter motor activated. Release the
key as soon as the engine starts.
STARTING A PETROL
ENGINE
Note: You can only operate the
starter for a maximum of 30 seconds
at a time.
Cold or hot engine
CAUTION
When the temperature is below
-20ºC, switch the ignition on for
at least one second before starting
the engine. This will make sure that
the maximum fuel pressure is
established for starting the engine.
Fully depress the clutch pedal and
start the engine without touching the
accelerator pedal.