Motorola RG2200 User Manual page 71

Problem
No power Power cord is disconnected.
VCR will not record VCR is on wrong channel.
VCR is programmed incorrectly.
VCR is not connected properly.
VCR is connected with RCA
jacks and is not in correct mode.
Safety tab on tape is broken.
VCR will not play tapes TV on wrong channel for play-
back or not using the correct
input.
VCR is not connected properly.
Amber On-line LED You don't have on-line services.
Amber Network LED The Gateway is not ready for
use.
Message on TV screen: TV program temporarily not
"There is a problem with the available.
network, Third video not
available."
Or, you are unable to make
channel changes.
Possible Cause
Check to make sure that the RG2200 is plugged into a live electrical outlet.
Note: If the outlet is controlled by a wall switch, make sure the switch is on.
See "Changing Channels" on page 22.
Refer to the VCR User's Manual.
See
Place the VCR on the LINE input. This can be accomplished using the VCR menu or
changing the VCR channel until the display on the VCR indicates LINE.
Use a new tape.
Tune TV to correct RF channel.
See "TV/VCR/Audio Connections" on page 59.
Call your Network Service Provider to initiate service.
Unplug power connection on back of Gateway then reconnect if light stays on more than
10 minutes.
Wait several seconds and try again. If you are still unable to make the channel change,
turn off one of the other TV programs by shutting off the TV with the remote. The
RG2200detects that the TV program is no longer being watched. This should free up
programming for the other TV and should allow you to receive video on the third TV.
"TV/VCR/Audio Connections" on page
Try This
59.
71