Alternator Belt Inspection; Fuel System - Mercury 200 Optimax DTS Owner's Manual

Alternator Belt Inspection

1. Inspect the alternator belt and have it replaced by an authorized dealer if any of the following conditions are
found.
a. Cracks or deterioration in the rubber portion of the belt.
b. Belt surfaces rough or uneven.
c. Signs of wear on edges or outer surfaces of belt.

Fuel System

Avoid serious injury or death from gasoline fire or explosion. Carefully follow all fuel system service instructions.
Always stop the engine and do not smoke or allow open flames or sparks in the area while servicing any part
of the fuel system.
Before servicing any part of the fuel system, stop engine and disconnect the battery. Drain the fuel system
completely. Use an approved container to collect and store fuel. Wipe up any spillage immediately. Material used
to contain spillage must be disposed of in an approved receptacle. Any fuel system service must be performed in
a well ventilated area. Inspect any completed service work for sign of fuel leakage.
FUEL LINE INSPECTION
Visually inspect the fuel line and primer bulb for cracks, swelling, leaks, hardness, or other signs of deterioration
or damage. If any of these conditions are found, the fuel line or primer bulb must be replaced.
FUEL FILTER REPLACEMENT
Removal
1. Use the shaft of a screwdriver between the lugs on the filter cap and unscrew the filter.
Installation
1. Lubricate the O‑ring seals with oil.
MAINTENANCE
WARNING
!
57
ob01587