Reliability; Reliability Of The Monitor; Customization; Identity Customization - Philips 200WS8FS/00 Service Manual

11

RELIABILITY

11.1

Reliability of the monitor

The MTBF of the monitor has to be greater than 50.000 hours. The MTBF shall be calculated according to
the MIL Standard HBDK 217 E/F. The report about the calculation detail shall be provided on component
level before mass- production by TVI. The calculation shall be performed for a primary test/preset mode
under ambient temperature of 25°C.
12.

CUSTOMIZATION

12.1

Identity Customization

Refer to SKU
12.2

EAN /SAP Identification

Refer to SKU
12.3

Plastic

The plastic material of the monitor must be PC-ABS (Front/ back) ABS-HB (base).
Plastic type and color is released as follows:
Refer to MakeUp sheet/ Graphic sheet
12.4

Definition of serial number

Refer to Philips' definition
12.5

Definition of the barcode label

Refer to Philips' definition
12.6

Accessories

Refer to SKU
13.

ECR-HANDLING

Not any change without approved ECR.
Every ECR to the golden " samples" must be approved by PHILIPS, Even ECR for minor changes must be
released by PHILIPS.
For the ECR procedure the vendor has to send an ECR formular, necessary spec updates, datasheets and
a photo documentation. On based on documents, PHILIPS has to decide if samples are necessary till
release to changes. The vendor also has to proof be certificates and test reports, that the change has no
effect on safety, EMI and TCO03.
After testing, PHILIPS has to release or reject the change request.
200WS8 LCD 79