Care And Cleaning - Salton JE1372 Instruction Booklet

HOW TO USE
1. Ensure that all parts are securely in place then plug into the wall outlet.
2. Place the Pulp Container under the Pulp Chute and a juice collector or glass
under the Juice Spout.
3. There are three settings on the Switch:
ON - this starts the motor for juicing
OFF – Stops the motor and operation
REVERSE – Moves the Auger in the opposite direction.
4. Wash all food to be juiced. Cut into appropriate size pieces to easily fi t into
the Food Chute. Remove and discard any hard seeds, pits or unwanted
sections before juicing.
NOTE:
(a) When making carrot juice the length should be no more than 80mm (3"),
width 15mm (1/2"). Feed at intervals of 5 seconds.
(b) Do not put frozen fruit, vegetables or ice into the unit.
5. Place food into the Food Chute and the Juicer will pull in the food and start
juicing immediately. Use the Food Pusher if necessary to dislodge food that
is stuck in the Food Chute. NOTE: Do not allow the VitaPro Juicer to run
longer than 2 minutes without adding food.
IMPORTANT: Never place your fi ngers in the Food Chute.
6. For best results insert food slowly to allow pulp to be extracted. Do not over
stuff or rush the juicing process.
7. The VitaPro Juicer has a unique simple rinsing process to switch between
different kinds of juice. Simply pour water through the Food Chute. This will
rinse out most of the residue and you are ready to keep juicing.
8. When you have completed juicing turn the unit to the OFF position, unplug
from the wall outlet and follow the directions in the Care and Cleaning section.

CARE AND CLEANING

1. Follow the directions in the 'Disassembling the VitaPro Juicer'.
2. Using the Cleaning Brush provided, clean the Strainer Basket. Hold by the
top rim only and use the brush to clean the mesh.
3. Wash the other disassembled parts in warm soapy water. Do not use
abrasive cloths or cleansers.
NOTE: There is a silicone pad under the Juice Bowl that prevents juice from
exiting through the pulp ejector. When using the VitaPro Juicer ensure that
the silicone pad is fi rmly in place in the slot. You may slide the pad out and
use the opposite end of the Cleaning Brush if food is caught in the slot.
4. Wipe the Main Housing of the VitaPro Juicer with a damp cloth. NEVER
IMMERSE THE MAIN HOUSING OR PLUG IN WATER OR ANY OTHER
LIQUID.
5. Dry all parts thoroughly before assembling the VitaPro Juicer.
6. Cleaning the Juicer immediately after each use will reduce the stains on the
Juice Bowl, Sweeper, and Cover but carrots or other strong colours in food
may still stain the Juicer. We suggest using one of the following cleaning
procedures:
a) Soak in mild soapy water
b) Equal parts warm water to cider vinegar
c) Soak in ½ box of baking soda and warm water
d) ½ cup bleach in a sink full of warm water
6