Advertisement
Available languages
Available languages
4. Do not touch the attachment as it becomes hot during and after
use.
5. Make sure hair does not get sucked into the air inlets.
6. Do not use thinner, benzine or any other solvent to clean the
hair styler.
7. This hair styler is equipped with an automatic overheating
protective device. If the hair styler overheats, it will generate
cold air. Unplug it from the power socket. Allow it to cool down
for a few minutes before using it again. Check that no fluff, hair
etc. is in the air inlets and outlets before switching it on again.
PartsIdentification
1 Main Body
2 Attachment Release Button
3 Air Outlet
4 Hang Ring
5 Air Inlet
6 Cord
7 Power Switch/Speed Selector
0: Off
1: Cool mode
: Set mode
3: Dry mode
3
2
1
0
HowtoUsetheHairStyler
FixingtheAttachment
•
Align the attachment with the hair
styler as shown. Ensure that the
groove of the attachment and the
hook of the body are aligned with
each other. Insert the hair styler in
the attachment until it clicks.
•
Press the attachment release
button and pull out the attachment
to remove it.
IntroductionoftheAttachment
BlowBrush
Use for a natural hair style.
Take a small amount of hair and brush from
the inside pulling it down gently. Use your
free hand to support the motion.
3
Advertisement
