Fault Conditions - Worcester GreenStar DanesMoor User And Care Manual

a)
b)
E
c)
ACCESSING RESET BUTTONS:
PULL BOTTOM OF
FRONT PANEL OUT AND
LIFT TO REMOVE
10
OPERATING THE APPLIANCE
F F
E
F
OPERATING THE APPLIANCE

FAULT CONDITIONS:

The 'Demand' and 'Lockout' lights can indicate some
basic fault conditions:
Normal operation:
a) Demand light:
Light ON; demand for heat from the heating/hot
water system
Light OFF; boiler not firing, no demand from
heating/hot water system
Demand and Lockout lights:
b) Both lights ON, boiler not firing;
1 Check the oil level in the oil storage tank
2 Press reset button (E). Boiler should fire
3 If no response, wait 2 minutes - press reset
button (E) again
4 If lock out light stays on, do not attempt further
resets. Contact your service engineer for advice.
c) Both lights OFF, boiler not on, no heating/hot
water;
1 Ensure there is a power suppl y to the boiler
2 Check the programmer is set to on
3 Press reset buttons (F) for heating
4 If the demand light remains off, contact your
service engineer for advice.
F
USER INSTRUCTIONS & CUSTOMER CARE GUIDE
8-716-106-255a (03.05)