Chapter 4 Applock; Introduction; Setup A New Device - LXE MX5 Reference Manual

Introduction

LXE's AppLock is designed to be run on LXE certified Microsoft Windows mobile devices only.
LXE installs the program as part of the factory-installation process.
A mobile device running AppLock becomes a dedicated, single application device. In other
words, only the application or feature specified in the AppLock configuration by the
Administrator is available to the user.
AppLock also contains a component which sets configuration parameters as specified by the
Administrator.
When the mobile device is reset to factory default values, the Administrator may need to
reconfigure the AppLock application.

Setup a New Device

LXE devices with the AppLock feature are shipped to boot in Administration mode with no
default password, thus when the device is first booted, the user has full access to the device and no
password prompt is displayed. After the administrator specifies an application to lock, a password
is assigned and the device is rebooted or the hotkey is pressed, the device switches to end-user
mode.
Briefly, the process to configure a new device is as follows:
1. Insert a fully charged battery and press the Power button.
2. Connect an external power source to the device (if required).
3. Adjust screen display, audio volume and other parameters if desired. Install accessories (e.g.
handstrap, stylus).
4. Tap Settings | System | Administration icon.
5. Assign an application on the Control tab screen.
6. Assign a password on the Security tab screen.
7. Select a view level on the Status tab screen, if desired.
8. Tap OK
9. Press the hotkey sequence to launch AppLock and lock the configured application.
10. The device is now in end-user mode.
Note:
E-EQ-MX5PCRG-F-ARC

Chapter 4 AppLock

LXE has made the assumption, in this appendix, that the first user to power up a new
mobile device is the system administrator.
MX5 Reference Guide