Cleaning The Air Filter Element - Yamaha XV17AWZ Owner's Manual

Tightening torque:
Transfer case oil check bolt:
8 Nm (0.8 m·kgf, 5.8 ft·lbf)
To change the transfer case oil
1. Place an oil pan under the transfer
case to collect the used oil.
2. Remove the drain bolt, the oil
check bolt and their gasket to drain
the oil from the transfer case.
1 1
2 2
1. Transfer case oil drain bolt
2. Gasket
3. Install the drain bolt and its new
gasket, and then tighten the bolt to
the specified torque.
Tightening torque:
Transfer case oil drain bolt:
18 Nm (1.8 m·kgf, 13 ft·lbf)
PERIODIC MAINTENANCE AND ADJUSTMENT
4. Check the oil check bolt gasket for
damage, and replace it if neces-
sary.
5. Install the oil check bolt and its
gasket, and then tighten the bolt to
the specified torque.
Tightening torque:
Transfer case oil check bolt:
8 Nm (0.8 m·kgf, 5.8 ft·lbf)
6. Remove the oil filler cap, refill with
the specified amount of the recom-
mended transfer case oil, and then
install and tighten the oil filler cap.
NOTICE: Make sure that no for-
eign material enters the transfer
case.
[ECA10871]
Recommended transfer case oil:
See page 9-1.
Oil quantity:
0.40 L (0.42 US qt, 0.35 Imp.qt)
7. Start the engine and let it idle for
several minutes while checking the
transfer case for oil leakage. If oil is
leaking, immediately turn the en-
gine off and check for the cause.
7-16

Cleaning the air filter element

The air filter element should be cleaned
or replaced at the intervals specified in
the periodic maintenance and lubrica-
tion chart. Clean or, if necessary, re-
place the air filter element more
frequently if you are riding in unusually
wet or dusty areas.
1. Loosen the air filter case joint
clamp screw.
1. Air filter case joint clamp screw
2. Remove the air filter case bolts,
and then slightly pull the air filter
case out.
EAU45701
1
7