Table of Contents
Advertisement
Quick Links
INSTALLER: Leave this manual with the appliance.
CONSUMER: Retain this manual for future reference.
These instructions are supplementary to the Installation and
Operating Instructions supplied with the fi replace and should be kept
together. Refer to the Installation and Operating Instructions for proper
gas supply, safety requirements and operating instructions
200411-16
TC30.NG06C
TC30
CHALET II
BURNER KIT
INSTALLATION
INSTRUCTIONS
PART# TC30.NG06C
For use with:
Model TC30
Series C
5056.42907
Advertisement
Table of Contents
Related Manuals for T&C TC30
Summary of Contents for T&C TC30
- Page 1 Operating Instructions supplied with the fi replace and should be kept together. Refer to the Installation and Operating Instructions for proper gas supply, safety requirements and operating instructions TC30 CHALET II BURNER KIT INSTALLATION INSTRUCTIONS PART# TC30.NG06C For use with: Model TC30 Series C 200411-16 TC30.NG06C 5056.42907...
-
Page 2: Contents Of Package
See pages 9 – 11. slot and tighten screws. (Fig. #1b) 3. Remove access cover from side of fi rebox(Fig. #1c) Fig. # 1 Fig. # 1b SCREWS Fig. # 1c TC30.NG06C 200411-16... - Page 3 Red end to the connector marked by the red dot, white end to the connector marked 2 SCREWS by the white dot Fig.#2 & Fig.#3 BULKHEAD PLATE Fig. # 3 WHITE END TO RED END TO MODULE WHITE DOT RED DOT TC30.NG06C 200411-16...
- Page 4 PILOT SUPPLY TUBE MAIN GAS SUPPLY TUBE 6. Position the slots of the grate securing Fig. # 5 brackets over the holes in the fl oor shield and secure with the two screws (Fig. # 5). TC30.NG06C 200411-16...
-
Page 5: Glowing Embers
Install the right log into the grate and pull it forward into position as shown. Place the four remaining small logs on the fl oor of the fi rebox in the positions and order as shown. TC30.NG06C 200411-16... - Page 6 Fig. # 8 LOG #2 Fig. #9 LOG #3 TC30.NG06C 200411-16...
- Page 7 Fig. #10 LOG #4 Fig. #11 LOG #5 TC30.NG06C 200411-16...
- Page 8 Fig. #12 LOG #6 Fig. #13 LOG #7 Note: Improper placement of logs will cause sooting on internal parts and glass. TC30.NG06C 200411-16...
-
Page 9: Propane Conversion
(Fig. #15) components supplied with this burner: CAUTION The gas supply and electrical power shall be shut off before proceeding with the conversion. Fig #16 Remove the manifold assembly from the burner. (Fig. #16) TC30.NG06C 200411-16... - Page 10 10. Remove right hand brick panel (if installed) and access panel located on right hand side of fi rebox (See Fig. #27). 11. Remove the minimum rate screw located in the valve. (Fig. #23) Fig #20 Fig #23 Minimum rate screw TC30.NG06C 200411-16...
- Page 11 Fig #27 16. Attach the access panel to the side of the fi rebox with the previously removed screws. (Fig. #27) Note: Gasket must be installed with access panel. TC30.NG06C 200411-16...
-
Page 12: Gas Pressure Check
Correct gas pressure requirement: Supply Pressure Natural Gas Propane Min. Pressure 5.0" WC 12.5" WC (For purpose of input adjustment) Max. Pressure 13.9" WC 13.9" WC Manifold Pressure Maximum 3.8" WC 11" WC Minimum 2.1" WC 5.5" WC TC30.NG06C 200411-16... -
Page 13: Burner Flame Adjustment
Remove air defl ector from log grate (2 screws) create sooting on internal parts and glass. Loosen the Primary Air Shutter screw. Rotate the shutter to increase or decrease the amount of primary air. Reassemble in reverse order. TC30.NG06C 200411-16... -
Page 14: Replacement Parts
(WHEN ORDERING, INCLUDE PART NUMBER WITH DESCRIPTION) ITEM ..DESCRIPTION ..........PART NO. ITEM ..DESCRIPTION ..........PART NO. #4..PILOT ASSEMBLY.....TCRP.5005025 #1..CHALET II BURNER ASSEMBLY ..TC30.NG06C #5..MAIN SUPPLY TUBE ......5019.223 #2..7 PCS LOG SET ......... 5094.301795 #6..PILOT TUBE ........5019.225 #3.. - Page 15 TC30.NG06C 200411-16...
- Page 16 Technical support: 1-250-748-1184 Web site: www.townandcountryfi replaces.net 2975 Allenby Rd., Duncan, BC V9L 6V8 Printed in Canada...