Figure C-2 Sat Version 2.51; Table C-1 Comparison Of Etus - NEC Electra Elite IPK Installation And Maintenance Manual

Electra Elite IPK
___________________________________________________________________________________
Voice Mail (VMS, VMS+, VMP,
FMS, FMS+, CMS, CMS+)
ACD+
CTI
BSU, CCH, PRT, BRT
S 2 C
ECTION ONFIGURING
TO
This is an example of how to configure SAT to directly communicate with the SPE
card over the Ethernet. This example assumes that the SPE(M)-U( ) ETU has been
configured with the appropriate IP address information.
In order for SAT to communicate with the SPE(M)-U( ) ETU directly, the version of
SAT Technician or End-User must be version 2.51 or higher to properly support this
type of connection.
___________________________________________________________________________________
SPE Hardware, Installation, and Maintenance Manual
Board
SAT T
ECHNICIAN OR
SPE(M)-U10 E
VIA

Table C-1 Comparison of ETUs

Connector
DB9M
DB9M
DB9M
DB9M
E -U
ND
THERNET

Figure C-2 SAT Version 2.51

Document Revision 1
Type Default Connection
DTE 38,400 N81
DTE 38,400 N81
DTE 38,400 N81
DCE 38,400 N81
C
SER TO OMMUNICATE
D
IRECTLY
C - 3