Table Of Contents - Viking Professional & Designer 450 Series Installation Manual

Table of Contents

Warnings & Important Information ______________________________________ 3
Dimensions & Cutout Dimensions ______________________________________ 4
Specifications ________________________________________________________ 5
Custom Door Panel Specifications ______________________________________ 6
Custom Door Panel Installation Option _________________________________ 7
General Information __________________________________________________ 8
Site Preparation ___________________________________________________ 8
Water Supply _____________________________________________________ 8
Drain_____________________________________________________________ 8
Electrical Connections _____________________________________________ 9
Hardwire Conduit Option _____________________________________________ 10
Trim Installation Options _____________________________________________ 11
Counter Balance Spring Adjustment ___________________________________ 14
Installation Procedure_________________________________________________ 15
Performance Checklist _______________________________________________ 18
Testing for Leaks _________________________________________________ 18
Final Preparation _________________________________________________ 18
Service & Registration ________________________________________________ 18
2
IMPORTANT-
Please Read and Follow!
• Before beginning-please read these • Please ensure that this product is properly
instructions completely and carefully.
• Do not remove permanently affixed labels, • The installer should leave these instructions
warnings, or rating plates from the
dishwasher. This may void warranty or
create an unsafe product.
• Please observe all national and local codes.
Plumbing connections must comply with
W A R N I N G
applicable sanitary, safety and plumbing
codes.
Make sure that incoming voltage is the
same as unit rating. An electric rating
plate specifying voltage, hertz, and
amps is attached to the product. Wiring
the dishwasher with more voltage than
it is rated for may cause severe damage.
To reduce the risk of fire, electric shock,
or injury to persons, installation work
and electrical wiring must be done by
qualified technician in accordance with
all applicable codes and standards,
including fire-rated conditions.
W A R N I N G
Electrical power must be turned off at
circuit breaker or fuse box before making
electrical connections. Disconnect the
electrical power supply and place a tag at
the disconnect switch indicating that you
are working on the circuit.
It is recommended that a thorough site inspection be
Site Preparation
conducted PRIOR to unpacking and moving this appliance.
3
grounded.
with the consumer who should retain for
local inspector's use and for future
reference.
W A R N I N G
W A R N I N G
The dishwasher door may not stay open
by itself until the door panel is installed.
Be aware of this when fastening the
dishwasher to the cabinet.
C A U T I O N
The dishwasher has a factory installed
backflow preventer. Do Not add an
additional check valve.
C A U T I O N
Failure to provide (20" [50.8 cm] above
floor level) a 20" (50.8 cm) high loop may
result in improper operation of the
dishwasher.