Controls, Connectors And Indicators - JVC TK-C1480E Product Manual

CONTROLS, CONNECTORS AND INDICATORS

TK-C1380E
1
Camera Mounting Holes (1/4-inch)
Use one of these threaded holes when mounting the
camera on a mount or turret. Two threaded holes are
provided on the front and rear and can be selected
according to the circumstance.
2
Camera Mounting Bracket Locking Screws (x3:
M2.6x5mm)
Do not use any screw longer than 5 mm.
3
Camera Mounting Bracket
The bracket has been attached on the bottom of the
cameras before shipment. It can also be attached on the
top according to the circumstance.
To re-attach the bracket use the threaded holes at the
top, with the 3 camera mounting bracket locking screw
2.
4
Backfocus Adjustment Ring
This ring both allows the adjustment of the backfocus to
and switch as the lens mounting method C and CS.
Loosen the BF LOCK screw 5 by turning it
counterclockwise before turning this ring, and be sure to
secure screw 5 by turning it clockwise after turning this
ring. The TK-C1380/TK-C1381 has been adjusted to the
optimum position for the C mount before shipment.
5
[BF LOCK] Backfocus Locking Screw
This screw locks the backfocus adjustment mechanism.
TK-C1480E
2
1
7
Lens Mount
1
This means to attach the lens.
This is applicable to both the C-mount lenses (1/2 inch)
and CS-mount lenses (1/2 inch).
Backfocus Adjustment Ring
2
Adjusting the back focus during lens installation.
When readjustment is required, loosen the locking
screw by turning it counterclockwise and turn the
3
back focus adjustment ring
After the adjustment, tighten the locking screw
again.
The TK-C1480 has been adjusted to the optimum
position for the C-mount system before shipment.
[BF LOCK] Back Focus Locking Screw
3
This serves to fix the back focus-adjusting ring.
Camera-Mounting Bracket
4
The bracket has been attached on the bottom of the
camera before shipment. It can also be attached on
the top according to the circumstance.
To re-attach the bracket use the threaded holes at the
top, with the camera mounting bracket locking screws
.
7
Camera-Mounting Screw Hole (1/4 inch)
5
Use this hole when mounting the camera
onto a fixer, pan/tilt unit, and the like. (Use a
screw shorter than 7 mm.)
Rotation-Preventive Hole
6
Make use of this rotation-preventive hole to prevent
any fall when mounting the camera. Make sure that
the camera is securely mounted.
Camera Mounting Bracket Fixing Screws (×2: M2.6
7
× 5 mm)
Do not use any screws longer than 5 mm.
3
4
5
6
.
2
3
MAX.
7
mm
16