Operating The Trekstor Hd Satreceiver Lunda S2; General Operation - TrekStor Luna S2 PVR Operating Instructions Manual

e) Inside this menu please choose the desired satellite by pressing the L or K button and
mark your choice by using the k button. In most cases that is the Satellit Astra 1H on the
position 19.2° E (storage location 002 inside the default satellite list). Below the channel
list you can find a bargraph, on which the "Q
In case you would like to change the settings, which are displayed within the right half of
the menu, press the M button and carry out the desired change. The settings concerning
the satellite system are saved by pressing the D button.
f ) Please press the blue button of the remote control. A window with the title "S
appears and you can carry out further settings. But usually no more settings have to be
adjusted here.
g) Start the station scan on the marked satellite with a new push on the blue button. It
appears the request "D
the default channel list, which contains the most popular channels of the German TV,
press the D button. The new channels will then be attached to the default channel list.
In case you would like to overwrite the default channel list, please press the k button.
While the channel search is running, you will be informed about the progress of the
search and about all found TV and radio channels.
h) After having completed the channel search, the channel list will be stored automatically and
the SatReceiver starts to playback. You can now edit the channel list by e. g. creating a favorite
list. You will find an instruction for that under the section "e

4) Operating the TrekStor HD SatReceiver Lunda S2

4.1) General operation

turning the satreceiver on/off
In case the SatReceiver is connected to the power supply, you can shift to the standby mode
by pressing the a button on your remote control.
In order to switch the SatReceiver completely off, you must disconnect it from the power
supply.
adjusting the volume
You can raise or lower the volume by pressing the M or N button.
If you keep the M or N button pressed, the volume changes constantly.
i
In case you are pressing the b button, you can switch off the volume completely (mute) as
well as loud again.
changing channels
There are several possibilities to change a channel:
• With the numerical keys (0 until 9) of your remote control you can insert the number
of the desired channel. If, for example, you would like to choose the channel number 23,
then press consecutively the keys 2 and 3 and wait until the channel was changed. As a
check the inserted numbers are displayed onto a small information field on the screen.
• With the K or L button of the remote control you can switch to the next respective the
previous channel.
EN 24
A c o t
eLete LL hANNeLS F
" of the current signal is displayed.
uALity
c S ?". If you would like to keep
he hoSeN AteLLite
t c
DitiNg he
S
tAtioN eArch
A F L
hANNeL ND Avorite iSt
"
".