Table of Contents
Advertisement
Available languages
Available languages
Power connection
•
Connect your SatReceiver only to a power supply system, which is located within the
specifications of 100-240 V AC, 50/60 Hz.
Protection of your satreceiver
•
If there is a thunderstorm, the SatReceiver should be switched off and the mains plug as
well as the antenna cable should be pulled off.
Please make sure that both the satellite antenna and the LNB are connected with the building's
a
lightning protection or another suitable grounding.
•
During longer absence (e. g. while being on holidays), disconnect as a precaution the
SatReceiver from the net and your antenna system.
Maintenance
•
Never open the housing of your SatReceiver. Otherwise there is the danger of an
electric shock.
•
Repairs during the warranty period may be carried out only by the TrekStor service team.
•
Please store the original packaging for safe transportation of your SatReceiver.
avoiding "Burn-In"
A long presentation of standing pictures (e. g. a test pattern) can damage your TV permanently.
i
Plasma screens, rear projection television and CRT TVs are especially susceptible for that.
Therefore please avoid presenting standing pictures for a longer time period on such devices.
1) Controls and connections of the HD SatReceiver Luna S2 PVR
1.1)Controls on the front side
A) Display: Shows you the number of the current station or further information while
operating the device.
B) Infrared receiver: Receives the signals of the remote control.
C) USB Service Port: Is located on the front side of the SatReceiver and will be needed e. g.
for firmware updates.
D) Operating mode display: Shows the current operating mode of the SatReceiver. The light
shines green while operating and red in the standby mode.
E) Program change button: With these buttons you can switch to the next respective the
previous channel of the current channel list.
F) Standby button: Switches between operation and standy mode.
A
B
C
D
E
F
19
EN
Advertisement
Chapters
Table of Contents
