Ipv6 Firewall - D-Link DIR-815 User Manual

Section 3 - Configuration
The DIR-815's IPv6 Firewall feature allows you to configure which kind of IPv6 traffic is allowed to pass through the device. The
DIR-815's IPv6 Firewall functions in a similar way to the IP Filters feature.
Enable Checkbox:
Check the box on the left side to enable the IPv6 firewall
rule.
Name:
Enter a name to identify the IPv6 firewall rule.
Action:
Use the radio buttons to Allow or Deny transport of the
IPv6 data packets according to the criteria defined in the
firewall rule.
Source:
Use the Source drop-down menu to specify the interface
that connects to the source IPv6 addresses of the firewall
rule.
Enter the source IPv6 address range in the adjacent IP
Address Range field.
Use the Dest drop-down menu to specify the interface
Dest:
that connects to the destination IP addresses of the
firewall rule.
Enter the destination IPv6 address range in the adjacent
IP Address Range field.
Select Schedule: Use the drop-down menu to select the time schedule that the IPv6 Firewall Rule will be enabled on. The schedule may be set to
Always, which will allow the particular service to always be enabled. You can create your own times in the Tools > Schedules section.
Protocol: Select the protocol of the firewall port (All, TCP, UDP, or ICMP).
Port Range: Enter the first port of the range that will be used for the firewall rule in the top port range field and enter the last port in the field
underneath.
Click the Save Settings button to save any changes made.
D-Link DIR-815 User Manual
IPv6 Firewall
70