Mounting Options - Honeywell DCCC6500 Quick Start Manual

Quick Start

Mounting Options

Quick Start: DC Charge Controller for Honeywell Wind Turbine WT6500 - Rev 2.0 - 29Nov11
Whichever mounting option design is chosen, it must be approved by a local PE. All of the
options listed have been rated and approved by our PE and certified for WindTronics, Inc.
Please refer to the following designs and their included specifications.
PERSONAL INJURY AND PROPERTY DAMAGE HAZARD
Do not install the Honeywell Wind Turbine in a location
that is accessible to children or pets. Failure to follow this
warning may result in death, personal injury or property
damage.
PERSONAL INJURY AND PROPERTY DAMAGE HAZARD
The Honeywell Wind Turbine must be mounted by
WindTronics Authorized Installers or other licensed
contractors only, with the use of all appropriate hardware.
Failure to follow this warning may result in death, personal
injury or property damage.
Failure to follow proper installation practices for any of the
mounting options could result in death, serious injury and/or
property damage.
When mounting on or over a combustible surface, a foot
plate of at least 1.43 mm galvanized or 1.6 mm uncoated
steel extended at least 150 mm beyond the equipment on all
sides must be installed.
Power shall be disconnected from the equipment before the
DCCC junction box enclosure is opened and the enclosure
shall be closed before the power is restored. Failure to do so
may result in death, serious injury and/or property damage.
If any maintenance is to be done on the turbine, the turbine
must be put in STOP mode, the turbine switch on the DCCC
junction box must be in the "Turbine OFF" position and the
wheel must be tie-wrapped to prevent turning. Failure to
do so may result in death, serious injury and/or property
damage.
Use of WindTronics' products for other than their intended
purpose may void the warranty.
7