Preface; General; Product Introduction - Kemppi 3200 Operating Manual

1.

preFaCe

1.1

general

Congratulations on choosing the Kempoweld power source. Used correctly, Kemppi products
can significantly increase the productivity of your welding, and provide years of economical
service.
This operating manual contains important information on the use, maintenance and safety of
your Kemppi product. The technical specifications of the equipment can be found at the end
of the manual.
Please read the manual carefully before using the equipment for the first time. For your
own safety and that of your working environment, pay particular attention to the safety
instructions in the manual.
For more information on Kemppi products, contact Kemppi Oy, consult an authorised Kemppi
dealer, or visit the Kemppi web site at www.kemppi.com.
The specifications presented in this manual are subject to change without prior notice.
important notes
Items in the manual that require particular attention in order to minimise damage and
personal harm are indicated with the
their instructions.
disclaimer
While every effort has been made to ensure that the information contained in this guide
is accurate and complete, no liability can be accepted for any errors or omissions. Kemppi
reserves the right to change the specification of the product described at any time without
prior notice. Do not copy, record, reproduce or transmit the contents of this guide without
prior permission from Kemppi.
1.2

prOduCt intrOduCtiOn

The power sources Kempoweld 3200 and 3200W with wire feeder unit WIRE 400 makes
together 320 A MIG welding equipment, which is suitable for heavy industrial use. To the
product range belong in addition also the power sources Kempoweld 4200, 4200W and
5500W. Kempoweld 3200W has inbuilt water cooling unit.
power source: Supply voltage of the power source is 3~ 230 V / 400 V. Voltage of power
source is adjusted with turn type switches; together 40 steps. The Volt/Ampere metering unit
MSD-1 (accessory) which is included in the power source displays voltage or welding current.
Wire feeder unit: The wire feeder unit WIRE 400 is a 4-roll driven unit, which is suitable for air-
or liquid-cooled guns. The unit may be turnable above the power source or it may be locked at
its place. You can use the WIRE 400 wire feeder unit equipped also with interconnection cable
and push-pull gun. KMW timer controls continuous, spot and cycle-arc welding. Accessory
unit KMW sync is needed for connection and use of push-pull guns.
notation. Read these sections carefully and follow
'NOTE!'
EN
3