Kärcher G2600XH Operator's Manual page 14

Symptom Cause
NO DETERGENT. Detergent suction tube not
properly
connected to the machine
Detergent is too thick
Filter on detergent suction
tube is clogged
Damaged or clogged deter-
gent suction tube
A high pressure nozzle is
attached
Metering valve closed
Spray nozzle is obstructed
GARDEN HOSE Loose fi ttings
CONNECTION
Missing/worn rubber
LEAKS
washer
SPRAY WAND Spray wand not properly
LEAKS
attached
Broken o-ring or plastic
insert
PUMP IS NOISY Not enough gas or engine
oil
WATER LEAKS Loose fi ttings
FROM PUMP (UP
Water seals are damaged
TO 10 DROP PER
or worn.
MINUTE IS PER-
Thermal protection device
MISSIBLE)
is activated.
OIL DRIP Oil seals are damaged or
worn
If the symptom you are experiencing is not listed
above, or if the provided solutions do not solve your
issue, please visit our extensive online trouble-
shooting database at:
www.karcherresidential.com/help
14 English
Solution
Check connection
Dilute detergent, for best results use Kärcher
detergent
Run warm water through fi lter to remove
debris
Remove obstruction or replace detergent
suction tube
Replace with black detergent nozzle
Open metering valve
Blow out or remove debris with fi ne needle
Tighten fi ttings
Insert new washer
Turn the swivel nut of the gun clockwise until
connection is tight
Call Customer Support
Check that hoses and fi ttings are air tight.
Turn off machine and purge pump by
squeezing trigger gun until a steady fl ow of
water emerges through the nozzle
Tighten fi ttings
Call Customer Support
Thermal protection device will auto reset.
Do not run pump for more than 5 minutes
without spraying
Call Customer Support
.