Table of Contents
Advertisement
Owner's Manual
HANDLING THE REMOTE CONTROLLER
.
The air conditioner will not operate if curtains, doors or other materials
.
block the signals from the remote controller to the indoor unit.
Prevent any liquid from falling into the remote controller. Do not expose
.
the remote controller to direct sunlight or heat.
If the infrared signal receiver on the indoor unit is exposed to direct
sunlight, the air conditioner may not function properly. Use curtains to
.
prevent the sunlight from falling on the receiver.
If other electrical appliances react to the remote controller. either move
these appliances or consult your local dealer.
8m
CAUTIONS
VCH SerieS
Location of the remote controller.
.
Keep the remote controller where its
signals can reach the receiver of the
indoor unit. (a distance with 25 ft (8m) is
.
recommended).
When you select the timer operation, the
remote controller automatically transmits
a signal to the indoor unit at the specified
time.
If you keep the remote controller in a
position that hinders proper signal
transmission, a time lag of up to 15
minutes may occur.
Replacing batteries
The remote controller uses two alkaline AAA dry
batteries (R03/LR03X2)
(1) Slide the cover of the battery
compartment out all the way until the battery
compartment is revealed, then replace the old
batteries with new ones.
(2) After step (1) is done, push the RESET
button.
(3) Before replacing the battery compartment
cover, confirm that the display screen on
.
the remote controller displays "0:00" and
that the colon is flashing.
After replacing batteries, reset the remote
controller clock.
6
Heat Controller, Inc.
Advertisement
Table of Contents
