Panasonic Viera TH-P54S20A Operating Instructions Manual page 57

FAQs
Chaotic image, noisy
No image can be displayed
Blurry or distorted image
(no sound or low volume)
Unusual image is displayed
"Shop" appears on screen
at switch on
No sound is produced
Sound level is low
or sound is distorted
Unusual sound from the
display unit
Sound is unusual
Pictures from external
equipment are unusual
when the equipment is
connected via HDMI
Note: Digital TV reception is only as good as the antenna and the antenna cabling delivering
the DTV signals to the television. Reliable digital TV reception requires high quality, robust DTV
signals which can only be achieved when using a TV antenna and cabling designed for digital
TV reception.
●
Further reading please visit: http://www.digitalready.gov.au/publications.aspx where you can
download 'The Digital TV Antenna Systems for Homes Handbook' information pdf file.
●
For your safety, the antenna and cabling should be inspected / installed by a licenced installer
that should comply with Australian Standard AS1417.1 for Domestic installations or AS1367
for MATV installations.
Connecting devices such
as DTV recorder / PVR /
VCR etc that also require
an antenna connection to
the digital television
56
Problem
●
Change the setting of "P-NR" in the Picture Menu (to remove noise). (p. 24)
●
Check nearby electrical products (car, motorcycle,
fluorescent lamp).
●
Is "Colour" or "Contrast" in the Picture Menu set to the
minimum? (p. 24)
●
Reset channels (p. 30, 31).
●
Turn off the TV with Mains power On / Off switch, then turn it on again.
●
"Shop" was selected in "Auto Tuning" (p. 12)
Reset settings in "Shipping Condition" (p. 34), then select
"Home" in "Auto Tuning" (p. 12)
●
Is "Sound Mute" active? (p. 10)
●
Is the volume set to the minimum?
●
Sound signal reception may be deteriorated.
●
Set "MPX" in the Sound Menu to "Mono" (p. 25).
●
When power is on, drive noise may be heard from inside the
display unit (not a sign of faulty operation).
●
Set the sound setting of the connected equipment to "2ch L.PCM".
●
Check the "HDMI1 / 2 / 3 Input" setting in the Sound Menu. (p. 25)
●
If digital sound connection has a problem, select analogue
sound connection. (p. 51)
●
Is the HDMI cable connected properly? (p. 43, 48, 49)
●
Turn Off the TV and equipment, then turn them On again.
●
Check an input signal from the equipment. (p. 52)
●
Use an equipment compliant with EIA/CEA-861/861B.
●
To maintain optimum antenna signal quality, use an 'F' type
TV signal splitter (as illustrated) when connecting two or
more devices to the same antenna socket.
TV
RG6Q Fly Lead
DTV Recorder /
PVR / VCR
RG6Q Fly Lead
●
Hint: Some degradation of the DTV signal may occur if you
are connecting the aerial through an external device (e.g.
DVD Recorder or Set Top Box). In this case it is better to
use a splitter and connect the aerial directly to both devices.
Actions
'F' type
Antenna Splitter
Out
RG6Q Fly Lead
in
Antenna Socket
Wall Plate