Gateway CG572E Service Manual page 6

On Screen Display (OSD) Control
To adjust an image size, position, and operating
parameters are quick and easy with the On Screen Display
control system, using the OSD Select/Adjustment knob. A
quick example is given below to familiarize yourself with
use of the controls.
Example;
Note: (Monitor and PC's power switch should be ON,
with an image or prompt on the screen). A single
press of the OSD Select/Adjustment knob will present
you the main menu as below:
8 0 0 x 6 0 0
H : 46.8 kHz
HO R IZ O NTAL
EXIT
OSD
USER
:
N A V I G A T E
To adjust this item, rotate the OSD Select/Adjustment
knob and push it at the point of the selected item.
The display will look like as below:
8 0 0 x 6 0 0
H : 46.8 kHz
EXIT
OSD
USER
:
A D J U S T
Listed below are icons, icon names.
Icon Description
Contrast: To adjust the image contrast level.
Brightness:
To adjust the screen brightness level.
Horizontal Size:
Horizontal Position:
Vertical Size :
To adjust the image height.
Vertical Position:
Pincushion:
To correct bowing in or out of the image.
Trapezoid:
To correct the geometric distortion.
Degauss:
Used to demagnetize the picture to give
a more accurate image and color.
V : 75 Hz
SIZ E
R
MORE
:
S E L E C T
V : 75 Hz
R
MORE
:
S E L E C T
To adjust the image width.
To move the image left or right.
To move the image up or down.
Icon
Mode Recall:
R
Advanced Option:
MORE
Tilt:
To correct the image rotation.
Parallelogram:
Pincushion Balance:
To correct balance on each side distortion.
Horizontal Moiré
Vertical Moiré
Color Select:
color level; 9300K / 6550K / USER.
Language Select:
To choose one of the five languages for the OSD menu.
Information:
USER
OSD Manager:
OSD
Exit:
EXIT
To make the OSD disappear on the screen.
Out of Frequency Range
When inputed video signal is not available, the message will
display as below:
O U T O F F R E Q U E N C Y
OPER AT ING F R EQUEN CY
Self Diagnosis
This monitor has a SELF DIAGNOSIS OSD feature that is
pops up when the signal cable is not connection between a
PC and a monitor. The message will be highlighted as
below.
M O N I T O R S E L F T E S T
Y O U R M O N I T O R I S
W O R K I N G C O R R E C T LY
C H E C K C O M P U T E R P O W E R
A N D M O N I T O R C A B L E
- 6 -
Description
To recall factory preset mode.
There are five kinds of options.
To correct the geometric distortion.
:To reduce moiré.
Moiré is caused by intreference
the periodical display pattern
with the periodical dot screen.
To select color temperature or set
There is information of video
modes-preset and user modes.
To adjust horizontal or vertical
position of the OSD image.
HF : 120. 0k Hz
VF : 110. 0H z
HF : 30-70kH z
VF : 50- 160H z