Table of Contents
Advertisement
Rolling code programming:
To train a garage door opener (or other rolling code
devices) with the rolling code feature, follow these
instructions after completing the "Programming"
portion of this text. (A second person may make the
following training procedures quicker and easier.)
1. Locate training button on the garage door opener
motor head unit. Exact location and color of the
button may vary by garage door opener brand. If
there is difficulty locating the transmitting button,
reference to garage door opener operator's manual.
2. Press "training" button on the garage door opener
motor head unit (which activated the "training
light").
Note:
Following step 2, there are 30 seconds to initiate
step 3.
Garage door opener
Instruments
Operation
and controls
Instrument
Driving
cluster display
3. Firmly press and release the programmed
integrated remote control transmit button. Press
and release same button a second time to complete
the training process. (Some garage door openers
may required you to do this procedure a third time
to complete the training.)
4. Confirm the garage door operation by pressing the
programmed button on the integrated remote
control transmitter.
Canadian programming:
During programming, your hand-held transmitter may
automatically stop transmitting. Continue to press and
hold the integrated remote control transmitter button
(note steps 2 through 4 in the "Programming" portion)
while you press and re-press ("cycle") your hand-held
transmitter every two seconds until the frequency
signal has been learned. The indicator lamp will flash
slowly and then rapidly after several seconds upon
successful training.
135
Practical hints
Car care
Technical
Index
data
Advertisement
Table of Contents
