Typical Applications; Sweeping On Dry Ground; Sweeping On Damp Or Wet Ground - Kärcher KMR 1250 B User Instructions

English

Typical applications

38
User Instructions
!
Caution while sweeping!
Do not sweep up packing bands, wires or similar items,
otherwise the sweeping mechanism will be damaged.
Do not sweep any burning/glowing objects.

Sweeping on dry ground

For a small amount of normal dirt
n on an even surface:
lower main brush
– set the lever to the middle position [
brush wear).
n on an uneven surface:
lower main brush
– set the lever to the lower position [
brush wear).
n switch on dust extraction
– set the switching mode lever to dry [
n for cleaning right up to the edges – lower the side brush
[ ].
At regular intervals:
n clean the filter,
n empty the waste hopper.
Notes: If you are sweeping up fine dust, use the side brush
as little as possible as it will increase the amount of dust
stirred up by the sweeper. If the side brush encounters an
obstacle, it automatically swivels back inside the outer
contours of the sweeper. You should nevertheless try to
avoid collisions.
While the sweeper is operating, the filter should be cleaned
approx. every 15–30 minutes (depending on amount of
dust).

Sweeping on damp or wet ground

Follow the same procedure as for sweeping on dry ground.
In order to protect the filter from moisture
n switch off the dust extraction
– set the sweeping mode lever to wet [
At regular intervals:
n empty the waste hopper.
KMR 1250 B
] (minimum
] (increased
].
].