Replacing The Hard Disk Drive - Lenovo S40–40 Hardware Maintenance Manual

Hide thumbs Also See for S40–40:
Table of Contents

Advertisement

Step 1.
Remove any media (disks, CDs, or memory cards) from the drives, shut down the operating
system, and turn off the computer and all attached devices.
Step 2.
Unplug all power cords from electrical outlets.
Step 3.
Disconnect all cables attached to the computer. This includes power cords, input/output (I/O)
cables, and any other cables that are connected to the computer. Refer to "Left and right views"
and "Rear view" for help with locating the various connectors.
Step 4.
Remove the computer stand. Refer to "Removing the frame stand", "Removing the monitor stand",
or "Removing the transformer stand".
Step 5.
Loosen the two screws
up to remove it from the computer.
Step 6.
To reattach the rear cover:
a.
Line up the pins on the computer cover with the mounting holes on the chassis, then put
the computer cover back in place.
b.
Secure the computer cover to the chassis with the two screws.
Step 7.
Reattach the computer stand.

Replacing the hard disk drive

Attention: Turn off the computer and wait 3 to 5 minutes to let it cool down before removing the cover.
Note: It may be helpful to place the computer face-down on a soft flat surface for this procedure. Lenovo
recommends that you use a blanket, towel, or other soft cloth to protect the touch screen from scratches
or other damage.
Step 1.
Remove any media (disks, CDs, or memory cards) from the drives, shut down the operating
system, and turn off the computer and all attached devices.
Step 2.
Unplug all power cords from electrical outlets.
Step 3.
Disconnect all cables attached to the computer. This includes power cords, input/output (I/O)
cables, and any other cables that are connected to the computer. Refer to "Left and right views"
and "Rear view" for help with locating the various connectors.
Step 4.
Remove the computer stand. Refer to "Removing the frame stand", "Removing the monitor stand",
or "Removing the transformer stand".
Step 5.
Remove the rear cover. Refer to "Removing the rear cover".
1
at the bottom of the computer, and then carefully lift the computer cover
.
Chapter 8
Replacing hardware
33

Advertisement

Table of Contents
loading

Table of Contents