Midea MSCI-07HRIN1 User Manual page 162

Control device MCAC-HTSM-2007-11
Mode selection button:
It is used to select mode, push the button one time, then the operation modes will change in turn as follows:
AUTO→COOLING→DEHUMIDIFY→HEATING→FAN
Remarks: no heating mode if wire controller is set as the cool only.
Timer on button:
Push the button to set TIMER ON, each time you push the button the time moves forward by o.5 hours.
When the set time is over 10 hours, each time you push the button the time moves forward by 1 hour. If want
to cancel the TIMER ON, then adjust the time of TIMER ON as 0.0
Timer off button:
Push the button to set TIMER OFF, each time you push the button the time moves forward by o.5 hours.
When the set time is over 10 hours, each time you push the button the time moves forward by 1 hour. If want
to cancel the TIMER OFF, then adjust the time of TIMER OFF as 0.0
CLOCK button:
Normally display the clock set currently (display 12:00 for the first electrifying or resetting). When push the
button for 4 seconds, the hour part on the clock display flashes every 0.5 seconds, then push button and
to adjust hour; push the button CLOCK again, the minute part flashes every 0.5 seconds, then push and
button to adjust minute. When set clock or alter clock setting, must push the confirm button to complete the
setting.
Confirm button:
The button is used at the state of CLOCK adjustment. After select the time, push the button to confirm then
exit, the current clock will display
RESET button (hidden):
Use a small stick with a diameter of 1mm to push the RESET button to cancel the current settings and get
into the condition of resetting
ON/OFF button:
Push the button at the condition of OFF, the OPERATION lamp lights, as the wire controller enters into ON
operation, simultaneously sends the information of operation mode set currently, temperature, fan speed,
timer etc. Push the button at the condition of ON, the OPERATION lamp extinguishes simultaneously sends
the OFF. If having set TIMER ON or TIMER OFF, the wire controller will cancel these settings before entering
into OFF, close the concern indicator, and then send the OFF information.
Fan speed selection button (FAN SPEED)
Select any one fan speed from "AUTO", "LOW"," MED" , and "HIGH". Each time push the button, the fan
speed will change in turn as fellow.
Adjustment button:
Push the button, indoor temperature increases. Push the button continuously then the temperature increases
by 1°C per 0.5 seconds.
Adjustment button:
Push the button, indoor temperature decreases. Push the button continuously then the temperature
decreases by 1°C per 0.5 seconds
Swing button:
Push this button for the first time when operation, it will start the swing function. Push the button for the
second time, cancel the swing function. (The function is available matched with the concerned unit)
Economical buttons:
Push the button to set the economical operation mode for air conditioner, push again then cancel the mode.
The operation mode is suitable for sleeping time..
Cool only/cooling and heating selection button (hidden):
Use a small stick with a diameter of 1mm to push the button to switch modes. For COOLING ONLY type, it
will be no heating mode when pressing MODE. The uniform mode is COOLING and HEATING at the factory.
LOCK button (hidden):
Use a small stick with the diameter of 1mm to push the LOCK button to lock the current setting, push the
button again then cancel the setting.
160 Control System