Yamaha 2003 FJR1300 Service Manual page 135

ANTI-LOCK BRAKE SYSTEM (FJR1300A)
12.Set the main switch to "OFF".
13.Remove the test coupler adaptor from the
test coupler.
14.Set the main switch to "ON".
15.Set the engine stop switch to "
• [D-6-3-2] Hydraulic unit operation test 2
WARNING
_
Securely support the motorcycle so that
there is no danger of it falling over.
1. Place the motorcycle on the centerstand.
2. Set the main switch to "OFF".
3. Remove:
• right inner panel (front cowling)
• front right inner panel (front cowling)
Refer to "COWLINGS AND COVERS".
4. Check:
• battery voltage
Battery voltage
Higher than 12.8 V
Lower than 12.8 V → Charge or replace the
battery.
NOTE:
_
• If the battery voltage is lower than 12.8 V,
charge the battery and perform hydraulic unit
operation test 2.
• If the battery voltage is lower than 10 V, the
ABS warning light comes on and the ABS
does not operate.
5. Connect the test coupler adaptor 1 to the
test coupler 2.
Test coupler adaptor
90890-03149
– 127 –
CHAS
".