Kidde SL177i User Manual page 3

FOR MODELS SL 177I and SL177
Strobe Light
User's Guide
ATTENTION! The model SL177 and SL177I strobe lights are designed to notify hearing
impaired individuals of impending danger, they have no detection means and MUST be
used in conjunction with operating Smoke, Heat, or Carbon Monoxide Alarms.
The model SL177I AC wire-in Strobe light can be directly interconnected with Kidde Safety
3-wire Smoke, Heat and CO alarms. It will produce an intermittent flash pattern (approxi-
mately 4 flashes, followed by approximately 5 seconds off) when triggered by a Carbon
Monoxide alarm and a steady flash when triggered by a smoke or heat alarm.
The model SL177 is a 2-wire device that can be used to add strobe light capabilities to
existing alarm systems produced by other manufacturers. A relay module or suitable switch-
ing device ( not included), which is compatible with the alarm system will be needed to
energize the strobe light. Consult the alarm manufacturer to obtain the proper switching
device for your specific alarm model.
Thank you for purchasing this strobe light. It is an important part of your family's home
safety plan. You can trust KIDDE Safety to provide the highest quality safety products. We
know you expect nothing less when the lives of your family are at stake.
For your convenience, write down the following information. If you call
our Customer Hotline, these are the first questions you will be asked.
Strobe Light Model Number(located on back of device)
SL771
Date Code (located on back of device)
Date of Purchase
Where Purchased
SL771I
LISTED
C
R