Bryant 302B Installation, Start-Up And Service Instructions Manual page 27

I. PRELIMINARY INFORMATION
Model No .............................................................................................................................................................
Serial No ..............................................................................................................................................................
Date .....................................................................................................................................................................
Technician ...........................................................................................................................................................
II. PRE-START-UP
____ Verify that all packing materials have been removed from unit
____ Remove all shipping holddown bolts and brackets per installation instructions
____ Make sure that – on the 060 size, only – the two wire ties fastened to the outdoor coils and
reversing valve/accumulator have been removed
____ Verify that condensate connection is installed per installation instructions
____ Check all electrical connections and terminals for tightness
____ Check that indoor (evaporator) air filter is clean and in place
____ Verify that unit installation is level
____ Check fan wheel propeller for location in housing and setscrew tightness
III. START-UP
Supply Voltage: L1-L2 __________ L2-L3 __________ L3-L1 __________
Compressor Amps: L1 __________ L2 __________ L3 __________
Indoor Fan Amps: __________
AIR TEMPERATURE
Outdoor-Air Temperature: __________ DB
Return-Air Temperature: __________ DB __________ WB
Heat Pump Supply Air: __________
Electric Heater Supply Air: __________
REFRIGERANT PRESSURES AND TEMPERATURES
Refrigerant Suction __________ psig
Refrigerant Discharge __________ psig
Suction Line Temp*__________
Discharge Line Temp† __________
Liquid Line Temp‡ __________
____ Verify Refrigerant charge using charging tables
____ Verify that 3-phase scroll compressor is rotating in correct direction.
* Measured at suction inlet to compressor
† Measured at discharge outlet from compressor.
‡ Measured at liquid line leaving condenser
START-UP CHECKLIST
(REMOVE AND STORE IN JOB FILE)
—27—