Dell OptiPlex GX1 Installation Manual page 43

4. Locate the battery and remove it.
The battery (see Figure 1) is mounted in a socket labeled "BATTERY" in the front-right corner of the system board (as you face the front of
the system).
Pry the battery out of its socket with your fingers or with a blunt, nonconductive object, such as a plastic screwdriver.
5. Install the new battery.
Orient the battery with the side labeled "+" facing up (see Figure 11). Then insert the battery into the socket, and snap it into place.
Figure 11. System Battery and Battery Socket
6. Replace the expansion-card cage as described in
7. Replace the computer cover, and reconnect your computer and peripherals to their electrical outlets and turn them on.
NOTE: If Enabled, the
ALERT! Cover was previously removed.
8. Enter the System Setup program
9. Enter the correct time and date through the System Setup program's Time and Date categories. Also, use the copy you made in
step 1 to restore the correct settings for other system configuration information. Then exit the System Setup program.
10. Turn off your computer, and unplug it for at least 10 minutes.
11. After 10 minutes, plug in the computer, turn it on, and enter the System Setup program. If the time and date are still incorrect,
see the chapter titled "Getting Help" in your Diagnostics and Troubleshooting Guide for instructions on obtaining technical
assistance.
Back to Contents Page
"Replacing the Expansion-Card
Chassis Intrusion option will cause the following message to be displayed at the next system start-up:
and confirm that the battery is operating properly.
Cage."