Dell OptiPlex GX1 Installation Manual page 16

the bracket's sliding tab on the drive-cage slide rail. Slide the bracket into place. Reinstall the screw you remove in step 4.
Figure 12. Inserting the Drive Bracket in the Chassis
NOTICE: You must match the colored strip on the EIDE cable with pin 1 on the drive's interface connector to avoid possible damage
to your system.
8. Connect one of the device connectors on the EIDE cable to the 40-pin interface connector on the back of the hard-disk drive
(see Figure 13).
Figure 13. Attaching Hard-Disk Drive Cables
NOTICE: You must match the colored strip on the EIDE cable with pin 1 on the system board IDE connector to avoid possible
damage to your system.
9. If it is not already connected, connect the other end of the EIDE cable to the IDE connector on the system board.
To locate the system board IDE connector, see
10. Connect a DC power cable to the power input connector on the back of the drive (see
Check all connectors to be certain that they are properly cabled and firmly seated.
11. Replace the computer cover, and reconnect your computer and peripherals to their power sources.
12. Turn on the peripherals connected to the computer.
13. Start the computer system.
NOTE: If the drive you just installed is the primary drive and no operating system is installed, you must start the computer using a
bootable diskette or CD.
To boot the system from a diskette, insert a bootable diskette (such as an operating system installation or recovery diskette) into
l
diskette drive A, and turn on the computer.
To boot the system from a CD, enter the
l
(such as an operating system installation CD or the Dell ResourceCD) into CD-ROM drive, and turn on the computer.
NOTE: If Enabled, the
ALERT! Cover was previously removed.
14. Enter the System Setup program
"System Board
System Setup program
Chassis Intrusion option will cause the following message to be displayed at the next system start-up:
and update the Drives: Primary and Secondary
Features."
and set the Boot Sequence
options.
Figure 13).
to CD-ROM First. Insert a bootable CD