Automatic Satellite Programme Recording - JVC HR-S9500EK Instructions Manual

28
Automatic Satellite
Programme Recording
This facility allows you to record automatically a satellite programme which is timer-programmed on your external satellite receiver.
Connect a satellite receiver to the recorder's AV2 IN connector and programme the timer on the satellite receiver; the recorder starts
recording when the signals input from the satellite receiver to the AV2 IN connector, and when there is no input signals the recorder
stops recording and the power shuts off.
Satellite Receiver Unit
DECODER
Mains outlet
Back of Recorder
IMPORTANT
Set "AV2 SELECT" to "SAT" on the Mode Set screen in step 3 of page 29.
If you set "AV2 SELECT" to "SAT"...
It is possible to view a satellite programme with the TV set to its AV mode even if the recorder's power is turned off.
The AV2 IN connector's input is the same signal that is controlled by the rear panel AV1 OUT switch as shown below:
a- If both the satellite receiver and the TV are compatible with the Y/C signal, set the AV1 OUT switch to Y/C in order to take
advantage of high-quality S-VHS pictures. (For connection, be sure to use a 21-pin SCART cable that is compatible with the
Y/C signal.)
b- If the satellite receiver and/or the TV are/is not compatible with the Y/C signal, set the AV1 OUT switch to COMP.
AV2 SELECT setting on
the MODE SET screen
SAT
NOTE:
Refer to the instructions supplied with your satellite receiver.
Outdoor Unit
Satellite Cable
VCR TV
AV1 OUT
S OUT
COMP. Y/C
AV1 OUT switch
Rear panel AV1 OUT
switch
COMP.
Y/C
ADVANCED OPERATIONS (cont.)
Aerial
21-pin AV input
connector (SCART)
TV Aerial cable
ANT. IN
RF OUT
ANT. IN
AV1 IN/OUT
R L
AUDIO OUT
JLIP
RF OUT
AV2 IN
PAUSE/
R.A. EDIT
AV2 IN connector input
signal
Composite signal*
Y/C signal**
Aerial connector
Back of TV
EXT.2
* The composite signal is a regular video
signal.
** The Y/C signal is a signal in which the
luminance and chrominance signals are
separated.
EXT.1