Remote Control; Remote Control Functions - JVC HR-S8850EU Instructions Manual

42
EN

Remote Control

Functions
Remote A/B Code Switching
The remote control is capable of controlling two JVC video
recorders independently; one set to respond to the remote
control's A code control signals and another set to respond to B
code control signals. The remote control is preset to send A code
signals because your video recorder is initially set to respond to
A code signals. You can easily modify your video recorder to
respond to B code signals.
A
Set the remote control code.
Press and hold VCR on the remote control for over 2
seconds, press the number key "2" and then press OK.
The remote control now can transmit B code signals.
B
Check the remote control code for the
recorder.
Press and hold 4 on the recorder for more than
5 seconds while the recorder is turned off. The code
currently set appears on the front display panel.
C
Change the code for the recorder.
Press any key on the remote control. The recorder will
now only respond to B code signals.
NOTE:
To set the recorder back to respond to A code signals, repeat the
same procedure as shown above, but in step 1, press the number
key "1" instead of "2".
REMOTE CONTROL