3.1 Hard Disk Installation
Caution: Please do not take out hard-disk when DVR is running!
(1) Open DVR upper cover carefully;
(2) Insert Power Cord and data cable into Pin of hard-disk tightly;
(3) Put the upper cover back carefully.
3.2 Camera and Monitor Connection
Connect camera signal to video input of DVR, and video output of DVR to Monitor via
BNC connector (Refer to section2.2-Rear Panel); or
If the camera comes with PTZ control function, you could connect RS485 A & B to the
according port of DVR respectively (refer to system figuration on Chapter 8).
3.3 Power Supply connection
Please only use the power adapter supplied with the DVR itself.
Chapter 3: DVR Installation
5