Playback Picture Adjustment - JVC HR-S8600EK Instructions Manual

24
Playback
Picture
Adjustment
1
MENU
2
Manual Tracking
Your video recorder is equipped with automatic tracking control.
For most tapes this will automatically adjust the tracking to suit
the particular tape you are playing. In some circumstances it may
be necessary to make manual tracking adjustments. This is
usually only associated with old or worn tapes or recordings
made on old or worn recorders. If the automatic tracking control
fails to operate correctly you will see noise bars across the picture
as shown on the left below. To correct this you can override the
automatic control and adjust
the tracking manually by
pressing the TV PROG
buttons.
OVERRIDE AUTOMATIC TRACKING
1
Press on the remote to engage manual tracking.
ADJUST TRACKING MANUALLY
2
Press TV PROG + or – to adjust tracking.
RETURN TO AUTOMATIC TRACKING
3
Press on the remote to re-engage automatic
tracking.
NOTE:
When a new tape is inserted, the recorder returns to the
automatic tracking mode automatically.
4
0
4
3 OK
TV PROG
ADVANCED OPERATIONS (cont.)
Digital TBC/NR
Your video recorder is equipped with the Digital TBC (Time
Base Corrector) that removes jitter from fluctuating video signals
to deliver a stable picture even with old tapes and rental
cassettes.
The on/off of Digital 3-DNR (Noise Reduction) which cuts noise
and enables clear picture reproduction is also linked to this
function.
* The default setting is "ON".
We recommend that you use the Digital TBC feature when...
... playing back a tape recorded on a camcorder.
... playing back a tape repeatedly used.
... using this video recorder as the player for editing.
ACTIVATE DIGITAL TBC/NR
1
Press DIGITAL TBC/NR so that the button lights up.
8
To turn off DIGITAL TBC/NR, press DIGITAL TBC/NR
again so that the light goes off.
NOTES:
If you play back a tape recorded under poor TV reception
condition, there may be cases where the picture becomes
more stable with Digital TBC/NR set to off.
When Digital TBC/NR is set to on, if you play back a tape
where certain types of signals are recorded (using a PC or
some character generators), the playback picture may be
distorted. If this is the case, turn off Digital TBC/NR.
Digital 3R
Digital 3R picture system applies edge correction to the luminance
signal to enhance detail.
ACCESS MAIN MENU SCREEN
1
Press MENU.
ACCESS MODE SET SCREEN
2
Move the highlight bar
(arrow) to "MODE SET" by
pressing %fi, then press
OK or
SELECT DIGITAL 3R SET MODE
3
Move the highlight bar
(arrow) to "DIGITAL 3R"
by pressing %fi, then press
OK or
RETURN TO NORMAL SCREEN
4
Press MENU.
NOTES:
Normally it is recommendable to keep "DIGITAL 3R" set to "ON".
Depending on the type of tape being used, picture quality
may sometimes be better with "DIGITAL 3R" set to "OFF".
MODE SET
#
AUTO CH SET
.
MANUAL CH SET
INITIAL SET
REC LEVEL CTL
R.A.
[5∞] =
[MENU] : EXIT
B. E. S. T.
#
PICTURE CONTROL
to set to "ON".
AUTO TIMER
O. S. D.
DIRECT REC
AUTO SP=LP TIMER
DIGITAL 3R
NEXT PAGE
[5∞] =
[MENU] : EXIT
MAIN MENU
EDITT
MODE SET
ON
AUTO
OFF
ON
ON
OFF
ON