Orion HCCA10002 Owner's Manual page 13

The Orion HCCA10004 amplifier offers four positive and four negative
output terminals for ease of connecting channel 1(LF), 2(RF), 3(RR),
and 4(LR) outputs to the speakers. The amplifier is stable to 2Ω per
channel. See diagrams below for possible configurations.
Four Channel Stereo Configuration
Channel 1/2 and channel 3/4 lowest recommended impedance is
2Ω stereo.
Crossover mode, output, and gain configurations are indepen-
dently adjustable between the front and rear channels.
Two-channel or four-channel input can be used for this configu-
ration. For source unit fading, use the four-channel input mode.
Channels 1/2 and channels 3/4 outputs can be individually config-
ured for high-pass, low-pass, or full range operation.
LF
RF
Figure 17
Figura 17
Abbildung 17
© 2009 Directed Electronics. All rights reserved.
Three Channel Configuration
Channels 1/2 are configured for 2-channel stereo operation.
Channel 1/2 lowest recommended impedance is 2 Ω stereo.
Channels 3/4 are configured for a single channel bridged out-
put.
Channel 3/4 lowest recommended bridged impedance is 4 Ω.
Crossover mode, output, and gain configurations are indepen-
dently adjustable between channels 1/2 and 3/4.
Two-channel or four-channel input can be used for this configu-
ration. For source unit fading, use the four-channel input mode.
Channel 1/2 and 3/4 outputs can be configured for high-pass, low-
pass, or full range operation.
Channel 3/4 outputs are configured for summed bridged opera-
tion for subwoofer.
LR
RR
Figure 18
Figura 18
Abbildung 18
LF LR
RF RR
13